mac new hard drive install with sata enclosure

It is easy to mount a 2.5” SATA hard drive disk inside by DIY and you can connect to computer via an existing USB 2.0 interface. EN261RF HDD enclosure is a new generation high performance SATA interface backup storage solution that allows you to install a huge SATA hard drive. Moreover, EN261RF works with operation it supported without any device drivers. Every disk writes (encryption) and reads (decryption) operation is completely transparent to user. It can encrypt the entire disk content bit by bit including boot sector and operating system without performance degradation. Please read this manual thoroughly before using and retain it for future reference.ĮN261RF hard drive secure enclosure is the ultimate guard for your privacy and confidentiality. 26Ĭhapter 1 INTRODUCTION This guide contains information of product features, 2.5” hard drive installation and device capability. 25Īuxiliary Power Cord and Power Adapter. Start in Windows 2000, XP, Vista and Mac OS. While you mention that your problem is that Disk Utility does not see your drive, if you are running 10.8.4 or later it may still be worth trying an earlier version of the OS.2.5” SATA Hard Drive Secure Enclosure User Manual When I rebooted into 10.8.5 the drive was recognised as a normal volume and I have been using it for my Time Machine backup ever since. When I restarted my Mac Pro with this Snow Leopard volume I was able to use Disk Utility to set the drive to one partition and GUID format.

I did not have a boot volume pre 10.8.4 but did have a Snow Leopard boot volume. However the normal format options were not available with 'Logical Volume Group' being the only option. I was running 10.8.5 when I encountered the problem I described above - drive not recognised but Disk Utility did offer to format it. I am not sure whether the bug is still present in Mavericks. I booted from a Snow Leopard boot drive which I keep on a USB Flash Drive and used Disk Utility to successfully re-format and partition the 3 TB drive. The solution was to boot from an earlier version of OS X.

I Googled the issue and found that 10.8.4 and 10.8.5 have a bug which was causing this problem to occur with drives of 3 TB and greater capacity. I could not set the partition and GUID option and it was not showing the full capacity of the drive. However Disk Utility formatted it as a “Logical Volume Group”. When I rebooted it was not recognised and required formatting. I recently installed a 3 TB drive in a drive bay of my 2008 Mac Pro.

Mac new hard drive install with sata enclosure